Sistemas automáticos de pruebas de arena SPC

Sistema automático de análisis de arena SPC que mide continuamente la compactabilidad, la resistencia a la compresión, la resistencia al corte, la humedad y la temperatura de la arena de moldeo preparada. Las correcciones a las adiciones de agua y aglutinante se realizan automáticamente, lote a lote.

Un sistema automático de pruebas de arena forma parte de un equipo moderno de recuperación de arena.
SPC is an universal measuring system with selective sampling to control the operation of batch mixers

at a conveyor belt transfer point - SPC II

For installation at a conveyor belt transfer point

– The standard system SPC II is preferably installed at a conveyor belt transfer point between the mixer and the molding line.

A miniature turntable continuously extracts small amounts of sand from the flowing sand stream and fills a cylindrical test container (Diameter 50 mm, height: 100 mm).

The sand sample will be tested for compactability and optionally for compression or shear strength, moisture content and temperature. The number of test samples per batch can be adjusted based on customer specifications. Based on the measured values, additions of water and bentonite for the next batch can then be corrected. The system consists of only a small number of moving components thereby guaranteeing long life expectancy with low maintenance requirements.

Example Sistemas automáticos de pruebas de arena SPC II

with Samples directly from the Mixer - SPC III

For installation on a mixer with sampling and preparation unit

– Here, the standard system SPC II and a sampling and preparation unit is mounted directly on the mixer.

The SPC III solution is suitable for all types of mixers with a fixed mixing drum. To mount the equipment requires an opening in the mixer’s drum wall of approximately 70 mm.
The sand sample is prepared and then dropped into the cylindrical test container. The same measurements can be taken as for the standard system.

Example Sistemas automáticos de pruebas de arena SPC III

Sampling from a belt conveyor - SPC IV

For installation at a conveyor belt with mechanical sampling device

– This system consists of the standard system equipped with a mechanical device capable of extracting sand samples directly from the conveyor belt.

This mechanical device can be designed in a variety of ways and will be developed with considerations of the customer requirements. This system is also capable of performing the same tests as the standard system.